Owner’s Manual Installation Reference … TOP STRAP BRACKET INSTALLATION – BO010-02 May 24, 2002 Page 4 of 9 OWNER’S MANUAL 4Runner Avalon Camry Sedan Camry Liftback Camry Solara Camry Wagon Celica …Child restraint seat top strap bracket installation procedures are provided to supplement the Owner’s Manual. Beginning with 2001 models, the top strap brackets are factory installed. The child restraint seat top strap assembly is not available as a service part. Contact the child restraint seat manufacturer for recommended top strap information, top strap to child restraint seatinstallation instructions, and top strap retailers. The top strap brackets can only be installed on vehicles that have nuts welded in place by the factory. The locations of these nuts can be found in the Owner’s Manual (for most 1983 and newer models.) Toyota does not recommend modifying vehicles that do not have nuts welded in place by the factory. Some Land Cruiser and RAV4 vehicles, prior to 2001 model year, may not have these nuts welded in by the factory…. CHILD RESTRAINT SEAT TOP STRAP BRACKET INSTALLATION – BO010-02 May 24, 2002 Page 2 of 9 Child Restraint Seat Top Strap Bracket Installation Obtain the exact year and vehicle model Toyota Owner’s Manual before beginning installation. 1. Confirm with the customer which seat location(s) they will be installing the child restraint seat. The Owner’s Manual seat section provides an illustration showing available top strap bracket location(s). The illustration page in the Owner’s Manual is provided in pages 4-9 of this bulletin. NOTE: Determine which kit parts are needed for each specific child seat location, by referring to pages 4-9 of this bulletin. 2. Remove a 20 mm diameter area of the carpet or trim material above the bracket mounting location. In some vehicles, a 20 mm circle is already pre-cut into the interior trim material. Once the interior trim material is removed, the nuts welded in by the factory should be visible. 3. If a 5 mm or 15 mm spacer is specified, remove the red lock washer from the Bracket Sub-Assembly (P/N 73709-12010) and remove the 10 mm spacer. Assure the red lock washer is re-installed onto the bolt. If a 5 mm spacer is needed, use the 15 mm bolt from the CRS Kit (P/N 04731-22012). Installation Procedure Bolt Spacer 100 mm (4.0 in.) Anchor Bracket 185 mm (7.3 in.) 345 mm (13.6 in.) Example of 1999 Camry Showing Three (3) Available Bracket Locations…
Download CHILD RESTRAINT SEAT TOP STRAP BRACKET INSTALLATION Camry 83 – 00 All Models Technical Service BULLETIN.Pdf
Download here